 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How do I add wall thermostat 2 my wall heater valve,Dayton 3e290.No wires on valve
I have a gas wall heater and the only way to turn on and off is to open bottom of heater and turn the knob on the Dayton 3E290 valve. I want to be able to run a wall thermostat but there are no places to add the wires. What can I convert the valve to so it accepts the remote thermostate
Thank you |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
After flushing toilets the hammer starts at end of flush cycle
I have a Moen single-handle tub and shower valve that I have installed. To this set-up, I added a diverter valve I found online that I hoped would take the full-flow of the water on it's way up from the pull on the spout to the shower head, and divert all of it to a wall-mounted hand held shower...
I have a toilet that does not flush all the way. I tried to repair it but it still does not flush all the way. I followed the directions of turning the water off and as soon as I turned the water back on it started to leak from the nob where I turned it off at... please tell me I can fix this and...
In my basement bathroom, inside the wall next to the toilet stop valve, there seems to be some kind of flutter valve activated. I can hear air being released as the valve flutters 4-5 times in rapid succession, with about a 2 second pause between these cycles. I can also hear gurgling water as...
I have an Empire wall heater model DV210 which failed to respond to the thermostat and turn on until I tapped the gas valve (7000 MVRLC-LP). This has happened only recently. Question: What are the conditions that encourage a valve to stick and is there anything I can do to discourage sticking...
View more questions Search
|
