Ask Experts Questions for FREE Help !
Ask
    otaunia's Avatar
    otaunia Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 4, 2012, 01:21 PM
    No heat with radiant floor heating system
    Hello, I have radiant floor heating with propane gas. We built our home in 2003. We have a through-the-wall gas water heater furnace. The problem is we have hot water, but no heat. I turned the thermostat off and back on and it clicks but nothing else. The unit does not click on except to heat water. My floor is cold and there is no heat, could I have a bad circulation pump and if so can I replace on my own?
    Thanks

Check out some similar questions!

Radiant Floor Heating in Bathroom [ 7 Answers ]

My wife and I are considering adding electric radiant floor heating in our master bathroom. The square footage is roughly 25-30 sq ft. They say that 1 SF is 12 Watts and 1 Amp per 10 SF of product. There is one outlet on the wall I was hoping to tie into for power, but after looking at our...

Demon in Radiant Floor Heating System [ 16 Answers ]

Greetings... new member here. I hope someone can help with this. MY SETUP: I have a hydronic radiant floor heating system. 3 zones; basement, 1st floor, 2nd floor. 1 pump per zone. Heat source is 50 gal Polaris water heater. Pex tubing is mounted under subfloor with aluminum plates,...

Is our radiant heat system heating our domestic water lines? [ 1 Answers ]

We have a radiant heat system installed 2 years ago as part of a remodel of our daylight rambler. The downstairs is heated by radiators, the upstairs by the in floor system. The tubing for the radiant system is clipped to the subfloor of the upstairs in the same interstitial space as the domestic...

Radiant floor heating book? [ 1 Answers ]

I'm trying to plan a radiant floor heating system for my house (built in 1912). I am basically redoing the entire house top to bottom so I figure I might as well change from radiators to radiant heating. I understand the concepts and have read everything I can find on it. I'm looking for a good...

Radiant Floor Heating [ 2 Answers ]

I purchased a ranch house with natural gas radiant floor heating. It takes about 4 hours to reach my set temperature. Then it overshoots the temperature. Once it gets back down to the set temperature, the concrete (with embedded copper pipes) is cold again, which means another 4 hours to get...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.