 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Carrier furnace problem
I have a carrier 58tma furnace and in the past year it has been displaying code 32.
Had it cleaned and inspected. Had the circuit board replaced also, which now I tend to think it didn't need to be replaced but tech said it did. After running last winter it displayed the code again and had to hit the reset button. Ran the rest of winter but after summer was through it kicked on and again displayed the code 32 and locked out. Had the tech back and he said the reset button had been tripped and says its due to a power surge and the sensitive electronics. He says this particular furnace is known for this. Can this be due to power surges? Even if the furnace hadn't been on for several months due to warm weather? Any ideas? |
||||
Check out some similar questions!
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
I have a 58rav115-16 caarrier unit. Lst week I replaced a suspected bad draft limit switch(code31) ran fine after. This morning I got up and the blower was running but it would not ignite. I switched to emergency heat and received a code31. I bypassed the draft switch and was able to get the them....
My carrier furnace would only come on if I shut down the main power then turned it back on. Then after it got up to the proper temperature it would shut off but not come back on. Now it won't come on at all. I just replaced the control board and it is doing the same thing.
Carrier furnace model 394JAZ060080AAFA ( about 19 years old) Fan (blower) comes on for two more short bursts after it shuts off during a heat cycle. I tried replacing the thermostat, but this was not the problem. This is not stopping me from getting heat (yet), but it is annoying. Any...
My furnace will not keep running. After approx 10 minutes of normal burning, the burners flame out and then re-ignite over and over again (about 1 second on/ 1 second off) and the gas valve can be heard clicking on and off. If the furnace is allowed to cool and turned back on the process repeats...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
