 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Janitrol heater new replacement surface ighjtor does not glow to start up furnace
Model # GMP075-3, serial #9310085870 motor 1/2 hp the connections look good and the initial motor starts up and runs just as the ist fjoor motor starts up then the igniter starts on that heater. Is there another step I am missing here. can you help point me in the right direction?
Mike |
||||
Check out some similar questions!
It is a GMP-125-4 Inducer motor starts, I can see the igniter glowing and all the burners start for a few seconds. Then it shuts down the status light on the control board goes out. If I restart the furnace again right away the burners only light for a split second
Bryant 80T will not heat but the blower runs. The Hot surface ignitor does not glow red and there are no wires running to the Flame Rollout Switche. How do I solve this problem and get some heat?
And the flame goes out. The flame sensor looks good the metal probe is not disclored could it still be bad? The heater work fine last year when I used it. This is the first time I started it up this season. I live in a duplex and the other heater is working fine so I believe that the chimney is...
Hi I got this Janitrol Furnace it worked fine. Until my basement flooded then it looks like the circuit board got wet and it was on at the time. So basically I ordered a new board suppose to be coming soon. What happened was when the furnace came on like there were no flames only a bright...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
