Ask Experts Questions for FREE Help !
Ask
    Ed Scott's Avatar
    Ed Scott Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 4, 2012, 05:32 PM
    Bryant 80T will not heat. Hot surface ignitor does not glow. What's wrong?
    Bryant 80T will not heat but the blower runs. The Hot surface ignitor does not glow red and there are no wires running to the Flame Rollout Switche. How do I solve this problem and get some heat?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Feb 5, 2012, 03:49 PM
    If the control board is giving you a fault code of flame roll out switch open. That's your starting point. I would look for the two wires that go to the roll out limit.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Inducer blower and hot surface ignitor not coming on [ 0 Answers ]

I have a ruud furnace I just put a blower motor in and I put all the wires back as on the diagram on my furnace but the ignitor or inducer blower is not working now what can be the problem

Intertherm M1MB hot surface ignitor powers up, burner comes on and then shuts down [ 1 Answers ]

Interthem L.P. gas M# M1MB 090ABW ignitor lights up, burner comes on and then in two seconds everything shuts down. The entire process repeats itself again. Board electronic yellow LED (burner) light never comes on and the red LED glows continuously. Not sure if board is bad. Unit has been running...

Blower working,hot surface ignitor not lighting up [ 24 Answers ]

My furnace is a Carrier,about 9 years old. My blower runs but there is no heat. Have done some research so I replaced the HSI because there was a white spot on it and it was not lighting up. It still is not lighting up. Could someone tell me what I should do next. Thanks.

Comfortmaker Furnace Hot Surface Ignitor Failure [ 2 Answers ]

I have an 1989 vintage Comfortmaker furnace. Over the past couple of years, the burner goes out shortly after it starts up. When I replace the hot surface ignitor, it starts working again normally. I have had to replace the ignitor lately every one to three months. I have had a technician look...

Hot surface ignitor [ 1 Answers ]

What would cause a hot surface ignitor to explode?

View more questions Search