What is the hight spec. for 100amp ser. Panel box from subfl in accord to NEC code

ampitup Posts: 2, Reputation: 1

New Member

Jul 16, 2012, 11:15 AM

What is the hight spec. for 100amp ser. Panel box from subfl in accord to NEC code

What is the hight spec. for 100amp ser. Panel box from subfloor in accord to NEC code.

tkrussell Posts: 9,659, Reputation: 725

Uber Member

Jul 16, 2012, 11:46 AM

Please explain your question.

Add your answer here.

Check out some similar questions!

Can I Update My 100amp Panel To A 150 Amp Panel Using The Same Awg2 Al-Triple Wire [ 1 Answers ]

Can I Update My 100amp Panel To A 150 Amp Panel Using The Same Awg2 Al-Triple Wire That's Coming Into My House From Meter? Or Will I Need To Update That Wire To A Larger Wire?

Panel spec.in use for moter drive use as remote panel [ 0 Answers ]

I want a panel spec. wich will have MCCB with auxlary contact on terminal block so that building management can use for a distance 50 mtrs. Kindly sugest mccb 400 amps incoming and different rating of MCCB for other loads.

Nec code for stapling wires from box [ 2 Answers ]

What is the code for stapling a wire after you staple from the electrical box

Electrical box hight [ 1 Answers ]

I was wondering what the standard hight is to install an electrical outlet box. I installed the boxes 12" from the floor to the bottom of the box was wondering if that is OK.I should note this is in a basement. Thank You Rob

100Amp disconnect panel before 100Amp main pannel [ 5 Answers ]

I would like to relocate my main 100Amp panel to the inside wall of my garage. Code saids the main panel must be on an outside wall. What I was thinking of doing Is install a New Main panel on the inside wall of the garage and put a 100Amp disconnect at the old panel location. I am aware of...