Ask Experts Questions for FREE Help !
Ask
    redneck42's Avatar
    redneck42 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 21, 2010, 11:42 AM
    Nec code for stapling wires from box
    What is the code for stapling a wire after you staple from the electrical box
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #2

    Jan 21, 2010, 01:47 PM

    I assume you mean romex (NM cable).
    If so then within 12" of any box or fitting.
    If the box is a single gang non-metallic box without a clamp or grip then it is within 8" of that box.
    Then 4-1/2' apart maximum.
    hermanwachs's Avatar
    hermanwachs Posts: 28, Reputation: 0
    New Member
    		  
    #3

    Jan 21, 2010, 05:42 PM

    That 12" is as measured along the wire. You can't have a big loop and then staple it. Around here they want a plastic insulator on the staple. Only two wires can go under a staple, If you have to fasten more use a cable stacker like 3M stak-it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Where to find NEC code USA on Internet [ 5 Answers ]

What site can I go to in order to find Electrical Codes for USA?

Outlet box with too many wires [ 2 Answers ]

Outlet box with fan, outlet, light combo, replaced switch and the outlet, Now the light will work but no power to the outlet, and the fan, Since I have Replaced the outlet,switch combo I cannot power up the outlet, Now the problem is frustrating me because when the existing wiring that...

Ceiling box has 2 sets of wires [ 2 Answers ]

I am trying to install a ceiling light to an existing ceiling box. I found two sets of wires, two black and two white in the ceiling box. I believe that this ceiling box is operated by a dimmer switch (just bought house and light was not installed). How do I wire the light?

Joining wires in a junction box [ 1 Answers ]

In wiring a house, I have each room's wiring pulled to a junction box in the attic. Each junction box will be a circuit, with a home run going from the junction box to the panel. There are more wires than a single wire nut can join. Do I use jumpers to group the entire bunch so that that all...

View more questions Search