Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
What would cause one hot wire (L1) to swell and the other hot wire (L2) to sag.
[ 5 Answers ]
When our fridge is plugged in, the voltage becomes unbalanced. Beforehand, L1 and L2 are both 120 VAC to neutral. After plugging in the fridge, L1 goes to 70 VAC and L2 goes to 170 VAC at the breaker box. The fridge appears to be OK because it will operate fine from our garage (on a separate...
Is hot wire is not a neutral wire or vice versa in single phase two wire AC source?
[ 1 Answers ]
I am a little bit confused why in AC single phase 2 wire source is merely classified the 1 wire as hot and other wire as neutral. The hot wire travels the current from the source to the load and going back the current to the source through the neutral wire. I know that in AC circuit, the signal or...
Can I wire a sail switch directly from 120v to the hot wire of a blower motor?
[ 13 Answers ]
I ordered a Honeywell model S688A1007 Sail Switch which I intend to wire N.O. to the hot wire on a blower motor (120 volt, 57 watt, 60 Hz, Panasonic FV-20NLF1 WhisperLine 240 CFM In-Line Fan), like a light swith would be wired. No idea about amp draw on this blower. I'm not an electrician and need...
Al wire on old trailer home, 120v on breaker but 50v on hot wire to outlet.
[ 2 Answers ]
Al wire on old trailer home, 120v on breaker but 50v on hot wire to outlet. View more questions Search
|