Replaced valve stem still leaking

Check out some similar questions!

Replaced valve seats on diverter and stem... water still runs from tub [ 2 Answers ]

Replaced all three stems on tub/shower and replaced seat on diverter valve... water still runs from tub spigot and shower at the same time

Leaking Shower/Bath Faucet. Replaced Stem, Assembly [ 0 Answers ]

Hello, I have leaking in my bath/shower faucet. It is a Danco kit. I believe the original was Bradley-Cole. After removing the stem, my old one had a hole on the end rubber piece. So I was pretty confident replacing it would fix it. After replacing it a pretty hard stream went to completely...

Leaking port on valve stem of sillcock [ 3 Answers ]

I have a leak just below the valve handle. When the valve is open and the water is flowing to the spigot opening, I have a significant leak (approx 5 gal/hr) from this port (see pic) on the value stem. While this pic is from a replacement sillcock, the problem is on a similar, but 20 yr. old...

Replaced Faucet valve stems and shower stem devirter [ 1 Answers ]

I have recently replaced my faucet valve stems and the shower devirter stem in the bath tub, and now the only thing that water is flowing through is the shower head and not the spot going in the tub. Also the shower devirter only makes a 1/4 turn.

Shower Valve Stem Replaced, Still leaking! [ 5 Answers ]

I replaced my Price Pfister shower valves, including diverter, and I cannot stop the slow drip from the spout into the tub. I am a novice DIY'er with an older 1930's triplex. There was no leak before with the previous valves but they were very old, tough to turn on/off, and had water temperature...

View more questions Search

Check out some similar questions!

Add your answer here.