 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
massplumber2008 answered original 11-19-11 question about joining PVC toilet flange to cast iron with bell end (hub) gone underground below slab. Not sure I understand his last comment: not acceptable above ground. I understood his response to be that I should use the "Mission"-style shielded...
I had my plastic tubal clamps put on when I was 21, and now I am 32 years old. I would like to have a baby now. As before I was in a very very abusive relationship so I decided to have only the 1 boy and 1 girl. That's when I decided to have them clamped. Rite now, I have someone new in my life and...
I will be plumbing my new kitchen soon and I am sold on thePex system except for the cost of the Pex clamping tool. I was wondering if I could use stainless steel worm drive clamps instead? I'm already using them on several connections already around the pressure tank etc. Thanks in advance...
Hi,what I have today is how to clamp down with 1.5 inch thick under layment I am looking for a clamp that will span this distance. We were going to put tile on then went laminate which is why we have 1.5 inch thickness,now I have to find clamps to hold down sink,we also put a air gap unit for...
I am going to be cutting into a 4" stack pipe to add a 2" T that feeds a new shower/sink. About a foot above where that T will go is where the toilet line meets the stack. Do I need to support the vertical stack with a riser clamp or can I just support the horizontal line from the toilet with a...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
