 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Does a furnace inducer need to be replaced?
I have a carrier furnace that was installed in November 2006. I had a tune up done and the technician said the inducer was vibrating. Should I replace it or will it be okay? The furnace is a 58MVB060 - high efficiency furnace. Thanks for any help you can give me.
|
||||
Check out some similar questions!
What is and inducer and a pressure switch
I replaced a draft motor on my ruud 80% gas furnace,everything works except I noticed that it ignites almost immediately,say 2-3 seconds after draft motor starts as before it was about 10 seconds,does this matter?. it has standing pilot... the new motor didn't have the small holes at bottom of...
What are the implications of a furnace inducer motor drawing high Amps?
What can be another solution to problem. Problem, inducer makes hummimg noise. Is $400 cost to replace and another $400 for labor?
I have a Keeprite furnace, model C9UHX100L 20AE. I was going to start it but no reaction was heard from the furnace. I checked the LED code. It said the pressure switch open when should be closed. I did a further check. The inducer motor was not running. Could you advise me what is the possible...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
