 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Draft inducer motor replaced on ruud furnace
I replaced a draft motor on my ruud 80% gas furnace,everything works except I noticed that it ignites almost immediately,say 2-3 seconds after draft motor starts as before it was about 10 seconds,does this matter?. it has standing pilot... the new motor didn't have the small holes at bottom of draft motor housing to mount the small safety type switch,so I mounted switch to one of the existing housing mounting screws? this switch looks like a small oval fire stat per se.. with 2 spade clips,1 on top and one spade on bottom and a mounting holes at each end of oval on switch,with a button type look,so I mounted it to draft motor housing at bottom with existing screw on housing that mounts to cabinet.. thanks for any help
|
||||
Check out some similar questions!
I have a Goodman GMH8 furnace that is three years old. The draft inducer motor goes on for about 2 seconds then shuts off and then keeps cycling until I shut the furnace off. It has been doing this for three days. My plumber came over and looked at it and after checking some wires it came back on....
My furnace's draft motor never stops even after one full heating cycle, which it's supposed to stop! This causes the pressure switch to stay closed even after the thermostat calls for heat the second time (after the initial heat cycle). When I stop and start the main switch in my basement,...
I trigger the furnace using the TEST lead to the common lead. The inducer motor starts (somewhat slowly), the ignitor glows, missing gas flow rom the GSV and then the blower tuns on and then shuts off. No fault code. I replaced the gas valve, no change. I checked the pressure switch for the draft...
Hello, I have a Heil SP80 natural gas induced draft fan furnace, model # NUG5075BFB2. The unit fires up normally and all is well until the unit shuts off when the temperature setpoint is reached. The draft inducer motor then cycles on and off shortly after the flame is shut down and for 20...
The motor is only making a "humming" sound. I have checked all the obvious stuff, loose connections, power to heat unit, tube to pressure switch, igniter, etc... All seams well. The motor itself will turn smoothly by hand but will not move when unit is turned on. I also have no spark at the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
