Ask Experts Questions for FREE Help !
Ask
    Bobxwh's Avatar
    Bobxwh Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 10, 2010, 02:32 PM
    Keeprite furnace inducer is not running?
    I have a Keeprite furnace, model C9UHX100L 20AE. I was going to start it but no reaction was heard from the furnace. I checked the LED code. It said the pressure switch open when should be closed. I did a further check. The inducer motor was not running. Could you advise me what is the possible problem?

    Thank you!

    Jan
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Nov 10, 2010, 07:27 PM

    Bird in vent motor? Or maybe motor is just burnt up. Remove motor and check for obstruction
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Keeprite Furnace Problems [ 2 Answers ]

I have an error 3 flashing dots which means"pressure switch open when should be closed" The unit is 13 months old. I can't get a tech out for 2 days everyone in my area is busy. Any help would be apprecaited.

Keeprite furnace [ 1 Answers ]

Between heating cycles the exaust fan comes on,the pilot glows,there is a little green light that flashes on ,off ,in the following sequences , o__000000__0__000000 , this lasts for about 2 to 3 minutes. Then the exhaust fan and pilot go off. No burner ignition occurs during this. This sometimes...

Keeprite furnace problems [ 1 Answers ]

Keeprite Oil Fired Warm Air Model FLO 115 Serial 1367 Age approx 25 years Problem - Started to occur over last 6 months, good for many years Under certain low barometric days no wind, exhaust fumes coming back through burner air in take 88 ppm carbon monoxide.

Keeprite furnace maintenance [ 1 Answers ]

I have a Keeprite furnace. There is a small plastic pipe 3/4 inch that runs from the furnace Into a 'cylinder' before going into the drain in the basement floor. The cylinder has now turned black inside. My questions are 1. What is this? Is it to do with condensation? ...

KeepRite Furnace Reliability [ 7 Answers ]

I'm in the market to replace my furnace with a high efficiency model, the contractor I'm talking with has recommended either a Goodman GMH95 or a KeepRite VS90, both are two stage. Does anyone have any comment on either, especially the KeepRite.

View more questions Search