 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Hi Rfwilds and Welcome to The Plumbing Page. At AskMeHelpDesk.com. You're responding to a 6 year old dead thread so I gave you one of your own. Look in then upper left hand corner of the first post form the date before you post, Thanks,
I have a slab and want to cut it to hold the vent pipe to the other side of the room
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Weather maker 8000 model 58WAV070-12 I cleaned the flame sensor and replaced glow rod. All steps proceed as normal until the burners are lit. There are three and the first two stay burning but the third starts and then shuts down quickly. This is the one in front of the flame sensor. I have...
Does the vent of a bath drain have to be directly over the drain? Can I tap into an existing vent (sink drain vent approx 6 to 9 ft away)
When you flush tiolet or let water out of tub or sink, if the vent is working properly will it force air out of the vent?
Hello all. I had a question about the vent coming out of the roof. In my kitchen, I have a cathedral ceiling framed with 2 x 12 joists. I was planning on bringing a vent from behind my sink straight up through the roof. I have a 18" overhang, and this will place the vent close to the edge of...
I was trying to layout a basement bathroom for a new construction home. Please view the attached file to see a schematic. I would like to place a vent behind the sink, and next to the bath. I'm not sure if this is adequate for the toilet placed between them. I was going to place the vent...
View more questions Search
|
