 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trane furnace troubleshooting?
Furnace is a TUY080R9V3V and is 11 years old. Beginning last year, it would not produce heat... no flame.
This year it is happening more often with a code of 2 flashes=EXTERNAL LOCKOUT (RETRIES OR RECYCLES EXCEEDED). I am thinking the hot surface ignitor might be the culprit or the flame sensor? This AM it took several tries to light the gas manifold, but it finally lit. This afternoon it was blowing cold air again. I reset it by shutting it off 3 times within 30 seconds and then it started OK. I am puzzled... and cold. Thanks, Rich wbcci3371atGmaildotcom |
||||
Check out some similar questions!
Troubleshooting guide on a trane xe-80 furnace
[ 9 Answers ]
I have a trane xe-80 furnace, And there is a code that flashes Thermal code protection. We have cleaned the heat sensors is there anythig else I can do to get heat till the Holiday weekend is over?/
Trane furnace troubleshooting - XV90 error code?
[ 4 Answers ]
My XV90 upflow furnace gives a 9 red flash code when it starts up. My installers guide says it is an "Open Inducer Limit switcch". The furnace works OK, should I be worried about this?
Troubleshooting a trane EX 70 furnace?
[ 0 Answers ]
Trane furnace xr80 troubleshooting red blinks
[ 4 Answers ]
Tranexr80 lights flash 5 times...
Troubleshooting Trane gas furnace.
[ 6 Answers ]
T-State is calling, vent fan is running, blower fan is running, have gas and valves open.. . But ignitor doesn't glow.. . Checked voltage to it and have less than 12V.. . What next?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
