 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a trane xe80 that blows cold air after a successful heat cycle.
I have replaced the hot surface ignitor and replaced the flame sensor as well. After I reset the breaker and turn on the thermostat, it will heat for 3-5 minutes and blow fine. Then I lose flame and it continues to blow cold air until I flip the breaker off. The code is 5 flashes. Flame sensed with gas valve off... Any ideas? And a great thanks in advance.
|
||||
Check out some similar questions!
I have a tranex e80 electric furnace Model vcm 15uls 115v-60hz 1.0a 1 phase The furnace is only blowing cold air. I have tried reseting it and no luck. The error code is 22 but there is no codes listed on the furnace & do not know what the trouble code means. The system cuts on, fans blow & you...
Removed the side panel. Turned gas off waited 5 min. Thermostat at min. Turned gas on, turned unit to heat, set to 80. Nothing happened accept blower kicked on. Heater never attempted to light.
It will work fine for even up to an hour... then it will stop igniting and blow cold air. I have to manually reset it at the thermostat or it will continually blow. I have cleaned the ingnitor scensor and that doesn't work. It works fine in warmer weather, but as it gets colder the symptoms come...
Blowing cold hair flames stay on only a few seconds and shuts off meanwhile furnace blows cold air themostat is set at 70
From my earlier post ignite for a few seconds the stops, now, heat commanded, blower motor runs, no ignition, and flashes code 22 Help!
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
