Ask Experts Questions for FREE Help !
Ask
    shaug25's Avatar
    shaug25 Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 26, 2011, 09:14 AM
    Do I have to remove freon to change high pressure switch on a heat pump?
    High pressure switch stuck open how do I replace it.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Nov 26, 2011, 09:54 PM
    You must be a trained and licensed tech to do this job
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #3

    Nov 26, 2011, 10:13 PM
    I have to agree with wmproop.

    Just know this. The high limit switch may have a quick connect seat that will allow for the switch to be changed without having to reclaim the refrigerant. Or it may be the type that has to be brazed in (which would require reclaiming and a whole mess of other steps and equiptment to do the job correctly.). A trained pro will know which you have.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I need to remove the well water pump pressure switch. [ 1 Answers ]

I need to remove the well water pump pressure switch. I'm sure the orifice is clogged AGAIN(two years ago). I did remove it, but forgot how I did it. Can you give me the individual steps to remove this switch? Deane

How do you change a high pressure safety switch on a luxaire heat pump [ 1 Answers ]

High pressure safety switch has yellow wires and apprears to be soldered on. Is that possible or does it come off without removing charge.

Amana Heat pump High pressure switch tripping [ 19 Answers ]

Called tech found unit pressure switch tripped, reset added freon. Lasted less than a week. Appears tripped again. He mentioned fan could be the culprit when he was out. Is there a way to eliminate this as a cause? Any other possible solutions? Brand new filter in unit after first episode.

Heat Pumo high pressure switch [ 1 Answers ]

Heat will work fine through a cycle but after it completes cycle it goes off on the high pressure switch. It is a Ruud. The indoor filter is clean and coils on condensing unit are clean. I have to reset condensing unit and it will run fine through that cyle then repeats problem. Any ideas as to...


View more questions Search