Ask Experts Questions for FREE Help !
Ask
    wworkerbee's Avatar
    wworkerbee Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 24, 2010, 12:49 PM
    How do you change a high pressure safety switch on a luxaire heat pump
    High pressure safety switch has yellow wires and apprears to be soldered on. Is that possible or does it come off without removing charge.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Mar 24, 2010, 01:54 PM

    Most of the luxaires are soldered on one. You can get tee's for the service ports and install one there. Whitout loss of freon.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Where is the high limit switch on a luxaire furnace [ 2 Answers ]

Where is the high limit switch on my luxaire furnace so I can reset it. As soon as it calls for heat the led light flashes red four times and the code is limit switch open. Everything starts up the ventor motor and the blower but there is no flame. I need heat

Luxaire heat pump [ 2 Answers ]

I keep replacing 3 amp fuses on furnace and they keep blowing.Why

Amana Heat pump High pressure switch tripping [ 19 Answers ]

Called tech found unit pressure switch tripped, reset added freon. Lasted less than a week. Appears tripped again. He mentioned fan could be the culprit when he was out. Is there a way to eliminate this as a cause? Any other possible solutions? Brand new filter in unit after first episode.

Heat Pumo high pressure switch [ 1 Answers ]

Heat will work fine through a cycle but after it completes cycle it goes off on the high pressure switch. It is a Ruud. The indoor filter is clean and coils on condensing unit are clean. I have to reset condensing unit and it will run fine through that cyle then repeats problem. Any ideas as to...

Luxaire heat pump [ 1 Answers ]

Older model luxaire heatpump will blow warm air in heat mode for several minutes then star blowing out cold air. Unit has new filter and coils are clean. The blower motor. Condensing motor and compressor run but blows cold air. Any suggestions on what problem could be?

View more questions Search