 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Clare hecla furnace blower runs continuously even when heater turns on.
Hi I have a Clare Hecla furnace and I have a problem where I've set the controls at OFF-110F and ON-150F with the limit at 170F. My furnace blower runs continuously 38mins to 24 minutes at a time and shuts down for a 2.5 minutes average. When the heater is on the blower continuous running and never stops for the heat. My heater runs on for 2.5 minutes and then shuts off for 12 minutes and turns back on. I'm trying to get the blower and the heater to run synchronized but the blower almost always runs continuosly. It is late October and its getting to -5C at night, so if anyone can give me some advice about what to do it would be much appretiated.
|
||||
Check out some similar questions!
I have a clare furnace model # HEM8 90-8 direct vent. The blower motor started making a lot of noise so I removed it and checked it out. There is a fan blade inside and it broke free from the piece that slips over the shaft. I tried to get it to stay which it did for a bit and it started...
I've just replaced the filter on my Bryant 310aav furnace, and there is no paper with fault codes glued to the inside of the door. There are fault code numbers in the owners manual, but without know what the series of flashing lights mean, there's no way to determine the fault code. 3 short...
I have a Rheem gas furnace and Carrier A/C. The furnace blower (which moves the air through the vent system) runs fine when switched-ON via the thermostat however after the AC turns ON for awhile, then the furnace blower stops (after various period of time). When this happens the blower does not...
I have a 376B Furnace and the blower is now running continuously. I found on another thread that this could be the Circuit Board. Is that the same as the "Carrier Inducer Control Board " which I find listed on the parts list. Any other suggestions that I could try first? How do I know if this...
Hi, I have a 1980's 100,000 BTU Heil Gas Furnace (Spark Ignitor type). The problem that I am having is that the Blower fan runs continuously after the heating cycle. I know that it should run for awhile after the heating cycle to cool the Burner etc to prevent warping, but the Blower just keeps...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
