Ask Experts Questions for FREE Help !
Ask
    Levert's Avatar
    Levert Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 22, 2011, 11:01 AM
    Nordyne m1mb his lights the burner but goes out
    New ignition his this is the flame sensor as well right would inproper location of ignitor/flame sensor cause the burner to light for few seconds then go out? What are some other troubleshooting measures? I have to bypass limit switch to get it to ignite?
    Handyman2007's Avatar
    Handyman2007 Posts: 988, Reputation: 73
    Senior Member
    		  
    #2

    Oct 22, 2011, 06:26 PM
    I believe you answered your own question. If a flame is not detected within a very short period, the gas valve will shut off.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Nordyne M1MB furnace will not start [ 2 Answers ]

Hello I am hoping someone could help me on this site. It looks to be very friendly and helpful! I have a Nordyne M1MB gas furnace that blinks twice which means the pressure switch is stuck open with the inducer blower on. This is about all the information I can find so far. I am wondering...

Nordyne M1MB 077A BW won't ignite [ 2 Answers ]

I replaced the ignitor, does this model have a flame sensor also where is the correct placement or a pic or diagram of them, Also if anyone has any other causes I would be very thankful I have messing with this for weeks and it's getting Colder, I'm about to get a bigger hammer and really...

Intertherm M1MB hot surface ignitor powers up, burner comes on and then shuts down [ 1 Answers ]

Interthem L.P. gas M# M1MB 090ABW ignitor lights up, burner comes on and then in two seconds everything shuts down. The entire process repeats itself again. Board electronic yellow LED (burner) light never comes on and the red LED glows continuously. Not sure if board is bad. Unit has been running...

Nordyne m1mb furnace burner ignites, will not stay lit cylces 4 times then lockout [ 1 Answers ]

My nordyne m1mb furnace burner ignites, howerver will not stay lit - it cycles through about 4 times, then locks itself out - the pressure switch appears to be okay and the thermocouple was replace two months ago

Gas Furnace - gas will not flow after HSI lights [ 15 Answers ]

Goodman Furnace Direct Ignition - Blower kicks on - pressure switch works - HSI heats up for about 8 secs -- NO GAS - HSI goes out Status light just blinks slowly, continuously until I let go of the panel switch. Gas valve is ON - ball cock is open - plenty of gas pressure (hot water...

View more questions Search