Ask Experts Questions for FREE Help !
Ask
    Levert's Avatar
    Levert Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 15, 2011, 09:52 AM
    Nordyne M1MB 077A BW won't ignite
    I replaced the ignitor, does this model have a flame sensor also where is the correct placement or a pic or diagram of them,

    Also if anyone has any other causes I would be very thankful I have messing with this for weeks and it's getting

    Colder, I'm about to get a bigger hammer and really fix this problem 4 good jk lol

    Thanks for any help
    JonesHVAC's Avatar
    JonesHVAC Posts: 173, Reputation: 12
    Junior Member
    		  
    #2

    Oct 15, 2011, 05:56 PM
    Flame Sensors are standard for safety. Tell us what happens after the thermostat calls for heat. Try and be as specific as possible. Thank you.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #3

    Oct 15, 2011, 06:01 PM
    http://www.nordyne.com/Literature/707977d.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Nordyne M1MB furnace will not start [ 2 Answers ]

Hello I am hoping someone could help me on this site. It looks to be very friendly and helpful! I have a Nordyne M1MB gas furnace that blinks twice which means the pressure switch is stuck open with the inducer blower on. This is about all the information I can find so far. I am wondering...

Nordyne furnace won't ignite [ 0 Answers ]

My Nordyne furnace model kg6ra 072c-12a won't ignite. The red light blinks twice and the yellow light doesn't blink at all.

I have a M1MB furnace where is the fuse located on the mother board? [ 2 Answers ]

No pwer to unit breakers OK but manual says check fuse on board where is the fuse?

Heater won't ignite. No pressure switch. Nordyne mmhb070 [ 1 Answers ]

My heater won't work. I checked the igniter and it's good. Everything keeps saying it's the pressure switch, but I don't think I have one. Any ideas?

Nordyne m1mb furnace burner ignites, will not stay lit cylces 4 times then lockout [ 1 Answers ]

My nordyne m1mb furnace burner ignites, howerver will not stay lit - it cycles through about 4 times, then locks itself out - the pressure switch appears to be okay and the thermocouple was replace two months ago

View more questions Search