Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Help getting back off dryer..
[ 2 Answers ]
My husband has tried to get the back off the kenmore elite dryer... so far the wires are still attached to top of dryer as he could not get in there to see how to disconnect them... he took all screws he found out on the back.. yet the top sits on the back... he is ready to chunk the dryer out the...
Back of dryer hot
[ 0 Answers ]
Hi there, I just bought a used washer/dryer set, and though I was told by the seller they both worked fine, the dryer seems to have some issues. It is a Frigidaire model FDE546RES1. First, there is quite a squeal when it runs, and from looking around online I'm led to believe it is the rear...
Back to back washer/dryer
[ 3 Answers ]
see attached picture putting in two sets of washer dryers on the opposite sides of one wall (2x4). I have an existing 2" drain coming out of concrete floor, everything else is planned i plan to put a clean out near floor followed by a sanitary cross branching out with a 2" vent to basement...
How do you take the back off a gas dryer
[ 1 Answers ]
How do you take off the back of a gas dryer
Take the back off my dryer
[ 1 Answers ]
I have a Prodigy dryer, when in use, it leaves black specks on clothes. I think the drum is loose, so I am trying to take the back of it off. I have taken all of the screws off the back, but it still is not coming loose. It looks like its perhaps "glued", maybe? Help! View more questions Search
|