Ask Experts Questions for FREE Help !
Ask
    stevenorris's Avatar
    stevenorris Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 11, 2011, 05:54 PM
    If my furnace fan is in lockout mode how do I re-set it ?
    10 yr old Payne central unit with control board.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jan 11, 2011, 06:32 PM
    Need to ask, what/how do you know its on lockout mode? There is several things I`ve never heard of ,and this is one of them. The entire furnace if so equipped can go into lock-out, but not just the blower,I don`t think. The blower could overheat and seize up and posibly start back up when it has cooled down,only to seize up again when it gets hot. Which means normally it needs replaced,, let us know with more info
    To reset furnace in lock-out you need to turn off power for a minute and turn back on,usually does it
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hot water tank stuck in lockout mode... [ 0 Answers ]

I have an A.O. Smith H2O tank with a power blower vented out the foundation of the house. All the thermostat controls are electronic and the entire system was new in 2007 when we built our house. All of a sudden the led panel is lit up indicating system is in lockout mode? Possible solutions in...

How to set auxiliary heat lockout [ 2 Answers ]

How to set auxiliary heat lockout.

Lennox Furnace fan only runs on slow speed in heating mode [ 4 Answers ]

I hope someone out there can help me under the control logic and components on my 1994 Lennox G20RE gas furnace. My fan runs at normal speed when it runs alone. When the furnace is in the "heat" mode, the fan only runs at minimum speed. It then overheats and begins to smell like it's burning up....

Furnace fan goes on when in manual mode but won't work on auto [ 1 Answers ]

This is a 15 old unit I checked it yesterday and everything seems to work all right on manual mode but when turned on auto it fallows all steps but when it sends signal for fan to go on it does not work

Furnace fan not starting in Auto mode [ 3 Answers ]

Hi, I have a Concord Gas Furnace with Carrier Central A/C. Today I found out that the blower is not starting whenever A/C kicks in. It doesn't auto start for heat either. Tried setting Fan in Always ON mode and still doesn't start. However if I turn off Heat/Cool and leave the Fan in Always ON...

View more questions Search