Ask Experts Questions for FREE Help !
Ask
    fkirby's Avatar
    fkirby Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 31, 2010, 09:18 PM
    HoneyWell RTH2310B Thermostat Installation question?
    Honeywell model is RTH2310B with RC, RH, W, Y, C connectors. My old thermostat has a Red wire and a white wire. I do not know where they connect. I do not have any ac in the room if that helps.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Dec 31, 2010, 10:07 PM

    Red to rh (if there is a jumper between rh and rc just leave it in. If no jumper, that's just fine too.) White to w. That should have you up and running.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rth2310b thermostat by honeywell [ 0 Answers ]

I just bought a rth2310b thermostat by honeywell. I have a gas boiler w/hot water baseboard heat. When took off the old thermostat,(not sure what kind , actually analog. None of the terminals or wires labeled.) There were only a red and a white wire. I came on here and checked out the faq, and saw...

Honeywell thermostat RTH2310B [ 0 Answers ]

I have a red yellow white green red orange black coming from the wall, but I only hooked up the red yellow green white, where do the orange and black hook up to

New Honeywell Thermostat Installation [ 0 Answers ]

We have Concord heat pump in our new home. There was a LuxPro thermostat connected to the system. I purchased a Honeywell RTH7600D in order to have a programmable thermostat. I replace the old thermostat with the new Honeywell (following the directions of the Honeywell Tstat). When I started it...

Honeywell Thermostat Installation [ 1 Answers ]

I didn't happen to look at the wires before disconnecting the old thermostat. I didn't think it was that difficult of task after doing mine. Ummm... then I looked at the wire colors! I've got R, W, G all coming from the furnace transformer. Green was not attached to anything, though. ...

A different Honeywell RTH3100C installation question - W2 wire? [ 1 Answers ]

"What to do with the W2 (and maybe W1) wire?" I am replacing an old Payne thermostat that controlled a heat pump system which provides heating and cooling, along with "emergency heat". The new unit is a Honeywell RTH3100C. I labeled all the wires as I removed the wires that were attached to...

View more questions Search