 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Rth2310b thermostat by honeywell
I just bought a rth2310b thermostat by honeywell. I have a gas boiler w/hot water baseboard heat. When took off the old thermostat,(not sure what kind , actually analog. None of the terminals or wires labeled.) There were only a red and a white wire. I came on here and checked out the faq, and saw something similar as far as my hook up goes, and so I hooked the red wire to the Rh and the white wire to the W. The boiler doesn't seem to be kicking on. This has been going on for an hour or so, So I tried to raise the thermostat temp to 10 degrees higher to kick it on and it is not kicking on, even though the 'flame ' icon on the thermostat shows that it is on. Still no heat . What should I do?
|
||||
Check out some similar questions!
I have a Carrier Series 50QT Electric heat pump that still uses the original non programmable thermostat. I am trying to replace it with Honeywell TH6000 series programmable thermostat. The wiring on the existing Thermostat as follows: O - White, I am thinking this is the Reversing Valve? Y...
I have a red yellow white green red orange black coming from the wall, but I only hooked up the red yellow green white, where do the orange and black hook up to
I thought the transfer of wiring would be intuitive, but I was clearly mistaken. I have a heat pump with an aux electric furnace. Current connections are (by color) X - blue W2 - white R - red G- green O - orange Y - yellow E - brown Can anyone tell me where these should connect on the...
Just a quick question.
Honeywell Deluxe Programmable Multistage Thermostat, #T8624D Chronotherm IV Plus I have 2 of above thermostats and have had for about 5 years. It takes no batteries and is directly connected to a 24 volt source. Have one upstairs and one downstairs. Have noticed at times that the LCD on...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
