 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Heil furnace requires power cycle and sometimes the burner will quit prematurely.
I have a Heil model H9MPD075F12C1 which requires a power cycle once in a while to start operation. On some occasions the burners will ignite and go out approximatley 15 seconds later. A couple cycles of this and the system will usually run normal for a while. A day or two later and we'll notice the system not running at all and have to cycle the power again. I noticed a post on cleaning the flame sensor and will try that for the burner issue.
|
||||
Check out some similar questions!
Overheats and shuts down. Should I repair the 10 year old furnace, or junk it for a new (different brand) new one? Ist repair person suggested replacement. Repair labor between $600-1000, heat exchanger, burner.
The burner ignites then it shuts itself off in like ten seconds
I have a Heil furnace model number NUGK075AG02 (75,000 btu's) and the burner ignites for about 15 seconds then goes out and the fan continues to run. What might be the problem? Deka
Hello, I have a HEIL furnace Mod# NTC6150KJA1. The air cycler timer is set for 30 minutes and once the time expires, the air cycler kicks on for about 3 seconds and then shuts off. It kicks on again 2 seconds later and stays on for 3 seconds and then shuts off. It continues this cycle for a...
My 1983 heil model NUGK075DG01, natural gas, forced air furnace is running but only heats the house to 67 degrees no matter how high I set the temp, the fan continuously runs (in auto on thermostat) and the burner will cycle for 3-4 min. then shut-off for 10 min.. I have powered down and back-on,...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
