 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have a York furnace that the igniter glows, small blower, the gas comes on and I get blue flames for about 3 seconds. The cycle repeats. The main blower does not turn on. I checked to make sure the exhuast was clear and there's no error codes on module. Also, the main blower works in 'fan on'...
I Manage a Apartment Community, most of the Apts have the York Furance. We are having propblems with the York Furnace pilots staying lit. I need some advice on what to do to correct the problem.
I have a York Gas Furnace (model# P2MPD14W08001B, 12yrs old) giving out no heat. I did basic troubleshooting and realised system was not igniting; replaced ignitor (changed original 4-5 years ago) - fired up initially and then went out after running for about 30 minutes. I cleaned the flame sensor...
My furnace has a intermmitent problem. When it quits the fault code is open limit. They all are closed. I can get it to work by moving the wires at the control board connector. The connections appear to be OK. I looked at the rear of the board and did not see any bad solder joints or cracks....
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
