Ask Experts Questions for FREE Help !
Ask
    TWINPEAKS's Avatar
    TWINPEAKS Posts: 3, Reputation: 1
    New Member
     
    #1

    Nov 27, 2010, 10:29 AM
    York p2ur natural gas furnace won't ignite
    TWINPEAKS's Avatar
    TWINPEAKS Posts: 3, Reputation: 1
    New Member
     
    #2

    Nov 27, 2010, 11:00 AM
    YORK P2UR NATURAL GAS Furnace WON'T IGNITE continued The glow plug doesn't glow, gas valve is open, burner doesn't ignite. Furnace runs the induced draft blower motor starts up and comes up to speed but it won't go any further. The draft motor keeps running. The next steps that should happen but doesn't are the venter start up, the hot surface igniter will glow, but these steps do not happen. The control board show a red flashing light that flashes three times over and over again. The thermostat works fine. We replaced the glow plug and the flame sensor. No luck at all. Don't know where to go from here and it is a cold day in Ohio with the first day of snow. Of all the luck. Any help would be greatly appreciated. Thanks

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to check natural gas pressure at furnace [ 3 Answers ]

How do I check gas pressure into my house?

I have a Concord 80 Plus Gas furnace, system tries to ignite, but does not. [ 0 Answers ]

I have a concord 80 plus gas furnace, the system tries to ignite, but does not. The system has a spark ignition system on it. The service repairman replaced the circuit board last December, but we seem to be having the same problem once again this December. Is there something wrong with the...

10 yr old bryant furnace doesn't always ignite smell gas [ 2 Answers ]

I have had a couple people look at my furnace and can't afford to pay the Bryant team! I replaced blower motor 2 years ago, furnace seems to run great once on, but when it kicks on sometimes I smell gas before and after cycles! I had to replace the inducer cooling fan, 3 weeks ago, now the smell...

Gas furnace won't ignite. [ 1 Answers ]

I have an Inter-City furnace and I installed an electronic thermostat. The furnace pilot will ignite, but when I turn the gas valve from pilot to (on) and turn the thermostat to ( heat), the furnace doesn't come on.

York gas furnace problem [ 2 Answers ]

My furnace has a intermmitent problem. When it quits the fault code is open limit. They all are closed. I can get it to work by moving the wires at the control board connector. The connections appear to be OK. I looked at the rear of the board and did not see any bad solder joints or cracks....


View more questions Search