Ask Experts Questions for FREE Help !
Ask
    lgooden's Avatar
    lgooden Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 23, 2008, 02:29 PM
    Problems with a York Furnace
    I Manage a Apartment Community, most of the Apts have the York Furance. We are having propblems with the York Furnace pilots staying lit. I need some advice on what to do to correct the problem.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 23, 2008, 03:44 PM
    Clean the pilot orifices to ensure full flame. Replace marginal thermocouples if so equipped. Check for down draft conditions in flue pipe. Make sure manifold pressure is proper for the unit. Check heat exchangers for cracks that can and will blow out pilots. A cracked heat exchanger can also kill you with CO. This is a very important issue to check. To do these jobs you will need special tools and the knowledge in how to use them. If you do not know this information I suggest you call for ON Site Service from a local HVAC company.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York furnace problems [ 4 Answers ]

Tried starting up my gas furnace this year everything seemed fine it lit but only stayed lit for about 8 seconds. I cleaned the thermocoupler and it still did the same thing. I replaced the thermocoupler and still has the same problem.The one thing that I have noticed is the draft inducer just...

Furnace Problems [ 2 Answers ]

I have a Comfortmaker furnace Model GNJ100N12C1 to be exact that will not turn on. We turn the thermostat to auto nothing turn it to fan nothing.

York Stellar Gas furnace Blower comes on NO heat [ 2 Answers ]

I am at a loss, furnace has a auto ignition, has tried to restart unit, but pilot does not appear to be one, air blows out of the vents, but no heat. :confused:

York furnace - No ignition,no heat [ 4 Answers ]

I have a York Gas Furnace (model# P2MPD14W08001B, 12yrs old) giving out no heat. I did basic troubleshooting and realised system was not igniting; replaced ignitor (changed original 4-5 years ago) - fired up initially and then went out after running for about 30 minutes. I cleaned the flame sensor...

York gas furnace problem [ 2 Answers ]

My furnace has a intermmitent problem. When it quits the fault code is open limit. They all are closed. I can get it to work by moving the wires at the control board connector. The connections appear to be OK. I looked at the rear of the board and did not see any bad solder joints or cracks....

View more questions Search