Ask Experts Questions for FREE Help !
Ask
    gvr64's Avatar
    gvr64 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 26, 2010, 11:37 AM
    Goodman furnace 1 blink on motherboard error?
    Furnace cycles on and off for 30 minutes, motherboard indicates a 1 blink message
    chefpierce's Avatar
    chefpierce Posts: 56, Reputation: 3
    Junior Member
    		  
    #2

    Dec 26, 2010, 02:55 PM
    Just a blink? Or is it like, blink blink... blink blink blink... blink? And the legend should be on the back of that panel... usually
    Rodneyacaldwell's Avatar
    Rodneyacaldwell Posts: 2, Reputation: 1
    New Member
    		  
    #3

    May 5, 2012, 01:21 PM
    It don't blink its off
    Rodneyacaldwell's Avatar
    Rodneyacaldwell Posts: 2, Reputation: 1
    New Member
    		  
    #4

    May 5, 2012, 01:25 PM
    Why don't the light and the mother brand don't work
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman GMPN060-3 (5 Blink Diagnostic Code) [ 4 Answers ]

Hi, I have a Goodman GMPN060-3 gas furnace. I get a 5 blink diag code, the indoor blower comes on. It worked OK for 3 hours this morning, I had to have the board replaced back Nov 04, I am wondering if it is going bad again, I am on disablity with limited income, any help will be gratefully...

My furnace keeps shutting off. The red light will blink once, pause blink again, pau [ 1 Answers ]

My furnace keeps shutting off. The red light will blink once, pause blink again, pause and so on. The only way to get it to go back on is if I go to the thermostat and slide the notch until I hear a click and turn it back up. I than go back to furnace unplug wire, plug it back in and it kicks...

My furnace has a seven red light blink error indicating that ignition lock out due to [ 2 Answers ]

Red light blinks seven times,ignition lockout due to retries.. does the igniter burn out ? It does not glow as it does in normal operation or is it more technical

Goodman Furnace Model GMPN080-4 one red blink [ 3 Answers ]

Furnace turns on the igniter glows but does not ignite (the gas valve is not turning on) it does this 3 times before turning off the circuit board blinks 1 time.. I replaced the flame sensor and it still does the same thing checked the gas valve and its not getting 24volts to it.. anybody have any...

Goodman furnace 3 blink [ 4 Answers ]

Greetings all, I've read through previous posts about this 3 blink error code and can't seem to find one relevant to what's happening to my furnace. It is a goodman ac/heater combo. The AC works fine, after being repaired over the summer with what I was told "a new blower and circuit board." ...

View more questions Search