Ask Experts Questions for FREE Help !
Ask
    marine111170's Avatar
    marine111170 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 12, 2010, 07:55 AM
    My furnace has a seven red light blink error indicating that ignition lock out due to
    Red light blinks seven times,ignition lockout due to retries.. does the igniter burn out ? It does not glow as it does in normal operation or is it more technical
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jan 12, 2010, 09:47 AM
    You can turn off power for a few seconds and back on to reset,, yes the igniter can and does burn out,, you usually can look it it and see a darkened /crack if you see that it needs replaced,, be careful they are fragile
    marine111170's Avatar
    marine111170 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 12, 2010, 10:41 AM
    Thank you so much it was the igniter... I have heat now!!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore Ultra Wash dishwasher won't start, red control lock light flashing [ 8 Answers ]

Kenmore Ultra Wash dishwasher won't start. The control lock red light (above the "start" pad) flashes when I press "start" or any of the control lights. The door is closed completely.

Propane Furnace won't start no pilot light red light flashes 3 times [ 6 Answers ]

My propane furnace G6RC has no visible flame and the red light either stays on or flashes 3 times in a row and then the furnace shuts off and tries to restart

The red light has a steady blink no hesitation [ 0 Answers ]

This is freongas again, I just wanted to say that the red light in the unit blinks the same no indication of a code. This is for the carrier 58gs100-2 that pilot lights but no fire and on blower is it the PC board?? Heeeeeeelp!!

Goodman Furnace Model GMPN080-4 one red blink [ 3 Answers ]

Furnace turns on the igniter glows but does not ignite (the gas valve is not turning on) it does this 3 times before turning off the circuit board blinks 1 time.. I replaced the flame sensor and it still does the same thing checked the gas valve and its not getting 24volts to it.. anybody have any...

Electronic ignition red light flashing sequence [ 1 Answers ]

I am trying to find a manual on a Concord furnace. At this time the blower starts but the burners do not light and then the system shuts down until power is cut and then turned on again and the same thing occurs, the rde light flashes 3 times before complete shut down occurs. What does this mean...

View more questions Search