Ask Experts Questions for FREE Help !
Ask
    gianetti's Avatar
    gianetti Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 23, 2009, 04:28 PM
    Goodman Furnace Model GMPN080-4 one red blink
    Furnace turns on the igniter glows but does not ignite (the gas valve is not turning on) it does this 3 times before turning off the circuit board blinks 1 time.. I replaced the flame sensor and it still does the same thing checked the gas valve and its not getting 24volts to it.. anybody have any ideas??
    letmetellu's Avatar
    letmetellu Posts: 3,151, Reputation: 317
    Ultra Member
    		  
    #2

    Oct 23, 2009, 06:34 PM

    There are some safety relays in different places on the furnace, look for them and reset them if needed.
    gianetti's Avatar
    gianetti Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 24, 2009, 04:16 PM
    Quote Originally Posted by letmetellu View Post
    There are some safety relays in different places on the furnace, look for them and reset them if needed.
    That was it.. thanks a lot :)
    roll's Avatar
    roll Posts: 5, Reputation: 1
    New Member
    		  
    #4

    Nov 10, 2009, 01:16 PM
    Quote Originally Posted by letmetellu View Post
    There are some safety relays in different places on the furnace, look for them and reset them if needed.
    How do you reset those safety relays?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman GMPN080-4 will not lite [ 3 Answers ]

I have a goodman gmpn0804 furnace that will not ignite (and the igniter is good) . The inducer motor runs, gas valve comes on, no ignition, gas valve shuts down . If I manually reset the furnace (turning the power off then back on) ? The furnace will lite, cycle several times it may run perfectly...

Goodman Furnace Model GMPN100-4--No Heat [ 3 Answers ]

The inducer fan motor starts,the hot surface igniter heats up and the gas valve opens producing a nice blue flame for 3 or 4 seconds and the gas valve shuts off. There are no red flashing lights to indicate a problem with any components. This unit was built around 1993. Any ideas on what might be...

Goodman Furnace Model GMPN060-3 Three Blinks Diagnostics. [ 7 Answers ]

I have a Goodman Furnace Model GMPN060-3. I get three blinks biagnostic code. I changed venter (motor assembly) and pressure switch. Still the same three blinks. Moisture drain path is clean and free of debries. After the new parts, furnace started once, but would not start again -- same three...

Goodman model gmpn080-4 [ 4 Answers ]

Have a goodman model gmpn080-4 I lost blower limit pressure switch previously and seemed to be the same thing, ordered part and still does same thing. Thought it may have had a vacuum leak so I sealed the edges, as long as it is not connected (securely) to the exhaust pipe it runs fine. As soon as...

Goodman furnace 3 blink [ 4 Answers ]

Greetings all, I've read through previous posts about this 3 blink error code and can't seem to find one relevant to what's happening to my furnace. It is a goodman ac/heater combo. The AC works fine, after being repaired over the summer with what I was told "a new blower and circuit board." ...

View more questions Search