Ask Experts Questions for FREE Help !
Ask
    Dave1952's Avatar
    Dave1952 Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 14, 2010, 03:59 PM
    visionpro th8000 that is coming on early
    We have a visionpro th8000 and the wake time is set at 6:15 AM. It is coming on around 4:30AM. I know it is suppose to come on earlier than what it is set at so it is warmed up when you get up. But an hour and 45 minutes sounds like a long time to me. Does this sound correct? Thanks for your help.
    Leighaeroe's Avatar
    Leighaeroe Posts: 1, Reputation: 1
    New Member
     
    #2

    Dec 20, 2010, 03:27 AM
    Sorry, no answer but I am having the same problem. I was searching the forums for an answer... I am thinking about replacing the unit - thinking it may be a bad board. Have you had any luck?
    Dave1952's Avatar
    Dave1952 Posts: 2, Reputation: 1
    New Member
     
    #3

    Dec 20, 2010, 01:30 PM
    Comment on Leighaeroe's post
    I talked to Honeywell and you might want to shut off the Feature they call "Adaptive Intelligent Recovery" This is a feature that measures how long it takes to warm your house up. Go to the setup functions and change code 530 to zero.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I'm trying to install a VisionPRO TH8000 honeywell thermostat... Help! [ 0 Answers ]

I am replacing an old 1070's WeatherTron stat Mod# 3AAT80B1A1 (or 2A1) 30 volt AC 1.5 amp for a GE Heat Pump with air conditioning. Wires: X2-Black, Y-Red w/Black, G-Green, O-Orange, T-White w/Black, R-Red, B-Black, W-White. I'm replacing it with a Honneywell VisionPRO TH8000 stat. HELP!! Thanks! ...

Miller thermostat change to honeywell visionpro serie th8000 only have 2 wires [ 1 Answers ]

How do I setup the honeywell with only 2 wires? 1 wire was hooked to W and 2nd wire was hooked to R on old one.

Wiring a Thermostat VisionPro TH8000 TH8110U1003 [ 12 Answers ]

Thanks in advance for taking my question. Let me level set. I am a homeowner not a contractor and thus my experience is fairly limited. I am attempting to replace two digital MapleChase 9610 thermostats that are connected to a two zone (mini zone Temp-A-Trol) panel. I called The zoning...

VisionPro TH8000 [ 1 Answers ]

Helo everyone Please help me with wiring system. I have honeywell thermostat th8000 and furnaces and heat pump My furnace have R Y G

Programming Honeywell VisionPRO TH8000 thermostat [ 1 Answers ]

How do I go about entering the temperature for my backup heat source (in my case, gas) to kick in? I believe it was set at 35 degrees, but I want to confirm. Thank you


View more questions Search