 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
No heat coleman evcon furnace
Topic: None Chosen
Your Question: "i have a coleman furnace model dgat056bdd i have replaced the ignitor and the sensor rod the combustion blower is ok the centrifugal is ok and the blower is ok too but this is what it is doing for heat it turns on the combustion blower turns on for about 30 sec. then the ignitor turns on for about 15 sec. then the gas turn on it burns for about 60 sec. then the blower turn on but when it does the gas turns off now the blower stays on the combustion blower stays on to after about two min. the gas turns back on for about 60 sec. and turns off it will do this 4 to 5 times then the furnaces turns off but the control board light is only blinking one time . now if i turn it off then it will run again just like it did before if anyone knows what is wrong i would be very thankfull for your help" |
||||
|
||||
|
Model dgat056bdd if you have a coleman evcon furnace I had mine go out well it was the sensor probe it right by the flame well it would light for about 60 sec. then go out it would do this about 4 to 5 times then this light would blink one time in which it means "ignition failure" well what I found out is that the sensor probe looked the same but the thickness of the metal has to be the same to you see the sensor probe is verey verey sensitive so I moved it closer into the flame also I learned that on the control board right near the little lite that you will see two little black square if you look close there is tempture setting that you can adjust . Just by pulling up on them and moving it to your tempture don't for get to use a owm meter to make sure you don't have any broke wires if you use a owm meter turn the power off!! My furnace is working good now
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Furnace will won't heat. Model #BGMO7516B Serial # 980905038. Red light blinks once. Will ignite but won't kick in to heat.
My home has coleman evcon furnace 12 years old.I can set the thermostat at 74 degrees and the furnace will start with a 30second purge then the ignitor will warm up and glow red then the main burner lights.then the burner stays lit and the blower runs for a couple minutes. Then the thermostat calls...
I have a Coleman Evcon heating and air conditioning unit, model # DGAT070BDD, year 1996, in my double-wide trailer home. It is making an odd beeping noise, something like an alarm. I can't seem to find a manual to help me diagnose the problem. Any thoughts to help me?
We recently bought a house with a Coleman Evcon heat pump installed in 1997. Everything seemed to be working fine until the night time temperature dropped below freezing. The next morning we noticed the temperature drop about ten degrees in the house and frost collecting on heat pump. I am aware...
We have a Coleman Evcon DLAS075BDD furnace which keeps displaying error codes: 1-Ignition Failure and 4-Limit cycling. We have replaced the circuit board. Inspected the ignitor and the flame sensor and both appear good. Also have taken the exhaust vent/hood off and vaccuumed out any rust to...
View more questions Search
|
