Ask Experts Questions for FREE Help !
Ask
    cathyk's Avatar
    cathyk Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Dec 3, 2008, 09:06 AM
    Coleman evcon furnace
    Furnace will won't heat. Model #BGMO7516B Serial # 980905038. Red light blinks once. Will ignite but won't kick in to heat.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 3, 2008, 12:32 PM
    Quote Originally Posted by cathyk View Post
    Furnace will won't heat. Model #BGMO7516B Serial # 980905038. Red light blinks once. Will ignite but won't kick in to heat.

    Try cleaning the flame sensor. Also look on the back side of the blower access door and post what one blink means from the diagram.
    Attached Images
     
    KScontractor's Avatar
    KScontractor Posts: 9, Reputation: 0
    New Member
    		  
    #3

    Dec 4, 2008, 09:52 PM

    It will be located on the top of the burners on a little shelf on the left side. Held in by 1 phillips head screw.
    KScontractor's Avatar
    KScontractor Posts: 9, Reputation: 0
    New Member
    		  
    #4

    Dec 4, 2008, 09:53 PM
    1 blink I believe is just ignition lockout
    fchasteen's Avatar
    fchasteen Posts: 1, Reputation: 1
    New Member
    		  
    #5

    Oct 9, 2012, 01:17 PM
    Have a coleman evcon red t furnace, when I checked unit , I discovered it wasn't working so I followed the "test" instructions.

    After powering unit back up and allowing it to cycle, I noticed that the indicator light was flashing twice. So I had the exaust switch replaced as the light guide siad it was stuck closed.

    However, after going through the reset instructions again I am still getting the same 2 flash signal from the light!


    Not sure what the problem is at this point, anyone have any idea
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman evcon furnace [ 5 Answers ]

My home has coleman evcon furnace 12 years old.I can set the thermostat at 74 degrees and the furnace will start with a 30second purge then the ignitor will warm up and glow red then the main burner lights.then the burner stays lit and the blower runs for a couple minutes. Then the thermostat calls...

Coleman evcon furnace [ 1 Answers ]

I have a coleman evcon direct vent forced air furnace, the air is blowing cool air, everythinig else is working it's firing ,the fan is working

Coleman Evcon furnace will not kick on [ 4 Answers ]

My daughter has a Coleman Evcon furnace in her mobile home. The problem is that every morning they wake up it is cold inside because the furnace failed to kick on during the night. She says it seems to work well during the day, however. Please help.

Coleman Evcon electric furnace [ 1 Answers ]

How do I know or rather how can I check to see if the repairman cut off one of the heating elements and where are they located?

Centrifugal- Won't come on Coleman-Evcon Furnace- [ 2 Answers ]

Hi, Just found your site today-yipee! I have a problem with my Coleman-Evcon furnace (it has had A/C added)-just bought the house this year, but previous occupants said all was working before. When I turn on the heat on the thermostat, I get a code 3 readout, "Centrifugal Swithch Open"; I had...

View more questions Search