Ask Experts Questions for FREE Help !
Ask
    purpleheart03's Avatar
    purpleheart03 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Dec 6, 2010, 12:51 PM
    Bryant plus 90 furnace, second part to question #1
    Everything works good and the LED light is solid, but as soon as it tries to ignite for the first time code 34 pops up, lights up for 2-3 seconds and then flame goes out and goes through the cycles and then shuts off. Ive check the condensation tubes and all are clear of any obstruction. I did some research and all came back to that flame sensor, is burnt out. I'm going to replace it and see what happens.

Check out some similar questions!

Bryant 383kv won't light error code 14, what part do I replace [ 7 Answers ]

The thermostat is calling for heat, 65 deg, the temperature is only 58 and furnace is in lock down showing error code 14. The furnace is a Bryant 383KAV. If I cycle the power to the furnace off and then on again, the furnace will start and run in a normal fashion. This has been happening more...

This is a multi part question. [ 5 Answers ]

I am 40 years old, I got married to my wife at the age of 20. We dated since I was too young to drive. I never really had any girlfriends prior to her, dated a few but nothing I would consider serious. We were each others "first." Somewhere around the age of 25, we both mutually agreed to see...

My Bryant furnace blows the 3 amp fuse when the furnace is kicked on, but ac works fi [ 0 Answers ]

Switch furnace to emergency mode on my Bryant 90 furnace [ 2 Answers ]

I have run out of propane and we are in the middel of a blizzard. How can I switch my furnace to emergency mode? Thanks, Brett

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.