Ask Experts Questions for FREE Help !
Ask
    BWriley's Avatar
    BWriley Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 6, 2010, 12:23 PM
    Switch furnace to emergency mode on my Bryant 90 furnace
    I have run out of propane and we are in the middel of a blizzard. How can I switch my furnace to emergency mode?
    Thanks,
    Brett
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Feb 6, 2010, 10:15 PM
    If you have a gas furnace,but have no gas, you in a heap of trouble, the furnace is your back up emergency heat sourse,when heat pump can`t do the job
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #3

    Feb 6, 2010, 10:17 PM

    The gas furnace is your emergency heat. Depends on what model you have if you can lock it in heat pump only.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant furnace roll out switch trips on low [ 4 Answers ]

I have a bryant 80,000 BTU 90 plus two stage furnace Converted to propane. The problem is when it is in the low heat cycle the roll out switch trips. But on high it does not. I currently have the furnace in the emergency run mode. I have already cleaned the combustion air and exhaust vents. The...

Blower in furnace works in heating mode, not in cooling mode [ 5 Answers ]

The furnace is an older model Carrier. I do not know at this time the exact model. It is at this time about 20 years old. The central air is a newer Carrier Performance series model. It is two years old. I have checked to make certain the blower moves freely; it does. The blower in the...

Furnace turns off at 'ON' mode and will not operate at 'AUTO' mode [ 6 Answers ]

The furnace will not turns on at "ON' mode. After some reading, I thought it would be the pilot light that has gone out. I re-lighted the pilot light to see blue-red flame, but the furnace will turn off AGAIN after 3-4 hrs. Replaced a new Honeywell non-programmable thermostat today with the...

Furnace turns off at 'ON' mode and will not operate at 'AUTO' mode [ 2 Answers ]

The furnace will not turns on at "ON' mode. After some reading, I thought it would be the pilot light that has gone out. I re-lighted the pilot light to see blue-red flame, but the furnace will turn off AGAIN after 3-4 hrs. Replaced a new Honeywell non-programmable thermostat today with the...

Bryant Furnace won't start flame on my emergency generator [ 4 Answers ]

My newer Bryant plus 80 T gas furnace would not start the flame when it was connected to my emergency generator during an ice storm that caused the commercial power to go out. Is this a result of the poor power quality of the emergency generator which messed up the electronic circuits of the...

View more questions Search