Ask Experts Questions for FREE Help !
Ask
    kcampton's Avatar
    kcampton Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 21, 2010, 08:22 PM
    3 Phase Feeder Size
    I am having a 3 phase 208 volt electric system installed in my wood shop. A 320 amp meter base is installed feeding 2 200 amp 3 phase panels. There is some question as to the size of the main feeders and the neutral wire size. I think I want copper installed but was told aluminum may be less cost. Thank you
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
     
    #2

    Oct 26, 2010, 05:59 AM
    Is this residential or commercial?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to compute for a 3 phase main breaker and feeder? [ 1 Answers ]

I like to know how to compute for the main breaker and main feeder line for a three phase supply and their branches are just single phase?

Feeder size for 200a sub panel [ 1 Answers ]

What I have is an added 2 car garage with a game room added and connected to the main house. Problem is the main service had to be moved to the exterior of the new garage. I picked up this job after someone else bailed on it. Anyway its been decided to put all the existing circuits into a 200a sub...

Feeder Line Size [ 1 Answers ]

I am rewiring an out building and am concerned about the size of the overhead feeder wire. I have aluminum triplex feeder wire with 7 strands of wire for each line. Is this wire heavy enough to carry 200 amp service?

How am I going to size my 3 phase X'mer with 1 phase load using current as reference [ 3 Answers ]

Hi, I'm Peping: I have 90 pieces of single phase loads with current of 2 Amperes. This will be loaded to a 3 phase transformer, Wye connected having a line to line voltage of 220 Volts. What will be the size of the transformer required for the mentioned loads? Many thanks, Peping

Feeder size [ 1 Answers ]

Hi, We are building a small art studio in our backyard. The power requirements for the building are: 1 dedicated 110V 20 amp circuit for a small kiln 1 dedicated 220V 20 amp circuit for a larger kiln 1 dedicated 110V 15 amp circuit for small wall-mounted heater/ac unit 1 dedicated 110V 15...


View more questions Search