 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a Hydrotherm boiler and a closed residential heating system that will not heat
I changed the boiler from "on" to "pilot" over the summer. The pilot light is still lit. I went to turn the boiler to "on" today, and set the zones to call to heat. There is no water moving through the system at all - no familiar gurgle - and the sheet metal chimney is not even warm. I don't know a lot about this at all, as it was sort of my ex-husband's thing. Am I missing something or there something else I should be doing?
|
||||
Check out some similar questions!
I have a 1974 Hydrotherm hot water boiler Model HC85 that uses a millivolt gas valve and an Auqastat to control the circullating pump. My problem is that lately if the boiler is not used for a day or longer because no heat is required I have to jump start the boiler when it calls for heat by...
I have an oil boiler in my building I want to cut off the hot water, from the other aptments but keep mine on how do I go about this.
I have a residential boiler system in the house I bought. When I turned on the water supply to the boiler from the water system in the house, the T&P relief valve blew. I am assuming that this is because the water pressure in my household system (approx 70 psi) is too high for the boiler. The T&P...
I have a Smith GV100W Propane Gas Boiler that is 13 years old. I getting a loud hot water pipe banging at the beginning of the cycle before the boiler comes. The gauge on the boiler shows less than 10lbs pressure currently. The hot water baseboard heating works fine except for this. I...
I'm trying to find out how to connect back up a milli volt gas valve some one pulled the thermo coupling and aquastat wires off the gas control valve hydro therm gas boiler model # hc180 app manufacture date was 1976
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
