 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Swapping old10.5 B & S for new 10.5 B & S Need electrical wiring help.
I'm swapping out a blown 10.5 HP electric start for a new Power built 10.5 & the new engine has more wires than the previous motor. The connector near the starter has 3 wires rather than 2 as the old one did .Anyone know how I need to connect it back there?
New engine is B & S model 215807 type 0324 electric start only. Thanks - D |
||||
Check out some similar questions!
Can substandard electrical wiring installation at home produce electrical arching? Then fire?
Trying to find out the cubic inches of 2/0 awg thhn wire
Please help! How do I connect a pull chain switch to a regular light fixture?:confused:
I have a 2 story house with 2 electrical panels. The house was built in the 60s. I want to move the panel in the living room to the panel in the basement, an install with 200 amp service. How do I go about removing the panel in the living room to the one in the basement without doing a total...
I currently have a 20 amp circuit for my frig outlet in the basement. I would like to install a recessed 6" IC Halo fixture on this circuit. To do so, can I use a 14/2 gauge wire or should I use a 12/2 wire which is meant for the 20 amp circuit?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
