Ask Experts Questions for FREE Help !
Ask
    howard68's Avatar
    howard68 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 5, 2010, 09:53 AM
    17.5 briggs motor need help with carb linkage
    Yes I have a ryobi riding mower with 17.5 briggs engine model# 31C707 type 0154E1 code # 020926ze. I am missing springs and linkage for the choke and from the governor. I need a detailed picture as the carb is mounted on the engine. Where I can see where they go and what they look like. Thank you for your help.
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Jul 5, 2010, 06:28 PM

    Look up the parts breakdown on Small Engines, Lawn Mower Engines and Generators by Briggs & Stratton.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

14.5 B&S OHV Carb linkage [ 3 Answers ]

I have an MTD Yard Machine with a B&S 14.5 OHV. I was given this mower a week or so ago by a "friend". It didn't run when I got it as it had been sitting for about a year. I freed up the motor and put a new battery and solenoid on it. I drained the gas and put some new in it and adjusted the...

B & S carb linkage [ 1 Answers ]

Briggs & Stratton carb linkage Need detail for linkage setup on 7 hp engine, including springs and control lever setup. Any suggestions on a source? Mojoo

18.5 Briggs Ic Motor Questions on Carb Problems [ 9 Answers ]

Hello I am Jim in Tennessee. I own a yardman Professional series Riding 42" Cut mower and it starts but can't find a manual for it anywhere on how to set the carb. I have emptied all old gas and new gas in it and even 2 new plugs in it and it dies after mowing for less than 3 minutes. Put a new...

Murray Riding (Briggs Motor) carb sputters quits -- too much fuel? [ 11 Answers ]

I have an old Murray riding motor that won't run for more than a minute or two. If I clean the plug, I can get it to start fairly easy but will start to sputter and finally stop after a minute or two. I took the carb off and made sure the float wasn't stuck -- it appeared fine. Running the mower...


View more questions Search