Ask Experts Questions for FREE Help !
Ask
    glp1954's Avatar
    glp1954 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 18, 2010, 06:41 AM
    I have an Amana 90 Gas Furnace
    I have an Amana 90 Gas Furnace with an Aprilaire thermostat. When I switch the thermostat to heat, it will not come on. The temperature reading for heat is higher than the room temperature, so that is not the problem. When I try the cool, the system works fine.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    May 18, 2010, 12:57 PM

    Look at the bottom door for a flash code.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Amana gas furnace starts then stops [ 5 Answers ]

The gas fires for a few seconds and then shuts off and restarts the cycle again. Usually it works the second time. Sometimes it locks out and has to be reset. I've cleaned/replaced the flame sensor. I checked the vacuum switch -ok

Amana gas heating unit will not heat. Gas valve comes on, ignites then goes off. [ 1 Answers ]

The gas valve comes on and I hear ignition. The flame then immediately goes out and the process repeats. I turned the unit off because as long as I leave it on the process repeats continuously.

Hi-limit switch failure on Amana gas furnace model 80SSE [ 0 Answers ]

Four blinks says reset hi-limit switch. Could not reset stuck button so I replaced it. Still blinks four times. What can I try next?

Amana gas furnace [ 1 Answers ]

Where can I find a natural to lp converter for amana furnace

View more questions Search