Hi-limit switch failure on Amana gas furnace model 80SSE

stevee68 Posts: 5, Reputation: 1

New Member

Oct 16, 2009, 09:33 AM

Hi-limit switch failure on Amana gas furnace model 80SSE

Four blinks says reset hi-limit switch. Could not reset stuck button so I replaced it. Still blinks four times. What can I try next?

Check out some similar questions!

Furnace Limit Switch [ 15 Answers ]

I've raised this issue in other forums. I have a high efficiency furnace that has worked flawlessly for the last four years (the house was built in 2000). This year we had to have the circuit board replaced. After that there was a problem with the blower, i.e. it wasn't shutting down after the...

Rheem Gas Furnace Fan limit switch settings Model # 3214-100fb [ 1 Answers ]

What are the proper settings for this particular model. The fan stays on way to long after the heat/fire shut down, which then causes the house to cool down quickly.

Furnace Limit Switch [ 6 Answers ]

I have Bryant upright furnace (Model 394GAW048100). Furnce runs fine for the first 4 or minutes in a cycle and then gas is cut automatically while the pilot is still on. After a few seconds, the gas again comes on and Furnace works fine for about 30 seconds, again gas is cut and so on. I changed...

Limit switch on electric furnace [ 1 Answers ]

Can the thermostat on a limit switch be bad while the rest of the switch is OK?My blower fan works manually but will not function on "auto".

Amana 80SSE running on Generator [ 2 Answers ]

We have an Amana 80 SSE and have it wired so that we can unplug the furnace from the electrical connection and plug it into a generator. We have tried this several times and it will start the blower and ignite the pilot but will not keep the furnace lit for more than about 10 or 15 seconds. ...

View more questions Search

Check out some similar questions!

Add your answer here.