Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Condenser Fan Motor Wiring for Goodman AC Heat Pump 3 Ton
[ 5 Answers ]
Condenser Fan Motor Wiring for Goodman 3 Ton -------------------------------------------------------------------------------- Hello Everyone, I have a GOODMAN A/C Heat Pump Model# CPLE 36-1 installed 3 years ago. Last week I turned the unit on, the compressor hums (not run)about 3-5...
Wiring replacement heat pump fan motor and capacitor
[ 15 Answers ]
Hi. My heat pump fan motor died. I got a replacement motor and capacitor but the wiring is a bit different for the new parts and I was hoping you could help me sort it out. The old capacitor had three terminals while the new one has only two. In the old setup, there were 5 wires to deal...
How to wire a condenser fan motor for carrier heat pump
[ 3 Answers ]
I ordered an AOSmith OCC1026 and they sent me OCC1026A. Specs seem the same, except the end without axle has open slots unlike old motor which was a solid plate. Is this a problem? I have a rain shield for the top and the motor would sit vertical. I thought I read somewhere that the occ1026a is...
Heat pump fan motor won't turn
[ 2 Answers ]
Hey I have rudd heat pump and the fan motor won't turn it turns about 2 inches and stop if I need a capacitor what size my model # rjma-a048jk serial # 5592 f219812989
Rudd Heat Pump needs Condenser Motor Wired
[ 1 Answers ]
My unit is a Rudd model# UPGB-025JAZ, 208/230 volts year 1997 I believe I have a single pole contactor with a 24 volt coil.. PS thanks for hanging in their with me! View more questions Search
|