Ask Experts Questions for FREE Help !
Ask
    sperley's Avatar
    sperley Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 17, 2010, 11:00 AM
    How to wire baseboard heaters
    What type of wire do I use from breaker 30amp double pole,240 volts to my 240 heaters.can I use 110.whats the best
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Apr 17, 2010, 11:05 AM

    30 amp requires 10/2 with ground, you may need to run 10/3 with ground if code requires it where you live.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

#12 AWG copper wire for baseboard heaters [ 18 Answers ]

I want to run a circuit for baseboard heaters and have been told to use #12 AWG copper. I have a total of three heaters in separate rooms each controlled by its own thermostat. I would like to use #14 AWG copper and have calculated the voltage drop with #14 to be less than 1% with all three heaters...

Wire for two baseboard heaters controlled by one thermostate on only one heater [ 3 Answers ]

Friends put down a floor and had to unwire my baseboard heaters. They couldn't remember how to rewire the heater with the thermostat. The heater with the thermostat works, but the other heater stays on. Here is how the heater with the thermost is wired: ...

Baseboard Heaters [ 6 Answers ]

I have connected two 2500w baseboards together as per instruction. I have connected them to the panel to a 30amp dp/dt breaker and am running them on a dedicated 14/2 using white for red. Cannot get appropriate heat from them even with thermostat on high. Have a small 250w wired same way will burn...

I am wiring 2 baseboard heaters. Not sure if I used the correct wire. [ 5 Answers ]

I am finishing my basement and have run all of the wiring from the panel to the wall where the thermostat will be and from there I have run the wire to the two locations where the heaters will be mounted. I am going to use a 6ft Fahrenheat and an 8ft Fahrenheat. They are 240v and I will be using...

Electric baseboard heaters -wiring 1 thermostat to two heaters [ 2 Answers ]

I would like to heat my new garage with electric baseboard heaters. The new garage is 20X24 feet. I would like to use only one 240V #12 2 wire circuit running two heaters at a total of 3800 watts. I plan to use 2 pole 20A breakers and 2c #12 wire. I would like to have both heaters controlled...

View more questions Search