 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
88 honda accord clutch
My accord has a fairly new clutch, less than one year, but when starting, I can't get the clutch to fully engage, either to get out, or into gear. When in gear with the clutch in, the car will still lurch as if the clutch has been dropped. When in neutral, the clutch won't engage to get into gear!
|
||||
|
||||
|
Check the clutch master cylinder reservoir. Ensure it's filled to the "MAX" line with brake fluid. If that does not solve the problem, assess whether the slave unit or the clutch master cylinder is bad. Check for visible signs of leaking. It's important to change the brake fluid in these units every couple of years, to replace the lubricity of the fluid and to purge soft rubber debris and crud from the clutch hydraulic system. I use a Brake Bleeder Economy One-Man, Cal-Van part no. 247, which contains a one-way check valve to prevent air from getting into the system, to safely change the fluid. This $2.99 bleeder only takes several minutes to bleed the system. I also use this tool to bleed my brakes every 2 years.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Would someone be able to tell me if the wheels on an 1986 Honda Accord are interchangeable with those of a 1996 Honda Accord. Thank you
When I depress the pedal on my accord (1993 5 speed manual w 204k miles) the pedal goes to the floor and sticks. I can start the car but cannot get it into gear. The pedal stays depressed and does not return to normal height. There is some fluid in the clutch fluid reservoir. What might be going...
Lost the pressure on clutch. Bled the line worked fine for 2 weeks. Went out again. Changed the slave cylinder. Still not clutch. Goes to floor won't engage. Changed the master cylinder. (old one showed signs of leaking) Tied to bleed the line. Still no pressure. Cutch stays to floor. Any...
I am losing clutch fluid from my LX Accord but cannot find any evidence on the floor or engine. Wwhere else should I look? Is it possible that the leak is so small that the DOT3 fluid evaporates before showing up on the garage floor? Thanks for any suggestions you might have. Vols
Hi I have a Honda accord 2.2i 1991. It has played up a bit recently, not starting straight away but the other day it just died while driving slowly down a country lane. The Rac breakdown guy said it was a suspect Distributor. How can I be Sure before I spend my Money. Thanks in advance Ivor.
View more questions Search
|
