Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Resitting vapor sensor on h2o heater in lockout?
[ 1 Answers ]
I need the lock out codes, or reset procedure for my Rheem h2o heater. It is a powervent, Robert shaw, low nox, gurdian system, 40 gal. residential. Model# 42VP4OSF I was painting my floor & the vapor sensor got tripped. It is now in lockout mode. I have tried turing off the power, & reseting it...
Goodman GDS81155CNA heater with Honeywell Mini Zone, built 3-30-2005.
[ 0 Answers ]
I have a Gooman 92K to 115K BTU heater and a Honeywell Mini zone three zone unit with two thermostats. The problem began when it started getting cold. The furnace would sometimes have problems starting, especially at night when it got colder. Then the furnace wouldn't start and was dead. I...
Kenmore Miser 12 Electric 40 Gal H2O Heater
[ 2 Answers ]
Let me get to my problem. I just installed a Kenmore Miser 12 Electric 40 Gal H2O Heater Model #153.321440. I have 120 coming from the breaker into each side of the thermostat (i.e. if I use my voltage meter and touch one lead to a ground and one to the black wire or red wire each gives me 120)...
Dual element h2o heater... wiriing scheme?
[ 3 Answers ]
Need a little help with 240v dual element schematic T
New Water Heater - No hot H2O in shower
[ 2 Answers ]
We just replaced our gas hot water heater today. We bled the lines and are not getting any hot water to come out of our shower head. We have a stand alone single knob shower stall. The hot water comes out of the tub faucets just fine as well as the sink in the same bathroom. Our home was built... View more questions Search
|