Ask Experts Questions for FREE Help !
Ask
    Steveodoud's Avatar
    Steveodoud Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Mar 22, 2009, 01:52 PM
    Resitting vapor sensor on h2o heater in lockout?
    I need the lock out codes, or reset procedure for my Rheem h2o heater. It is a powervent, Robert shaw, low nox, gurdian system, 40 gal. residential. Model# 42VP4OSF
    I was painting my floor & the vapor sensor got tripped. It is now in lockout mode. I have tried turing off the power, & reseting it etc.. PLEASE HELP!! E-MAIL is [email protected] Or cell# IS 269-270-4390:
    homeboy24's Avatar
    homeboy24 Posts: 4, Reputation: 2
    New Member
    		  
    #2

    Apr 7, 2010, 12:07 AM

    Follow reset procedures on the bottom of page 9... for flammable vapor lockout it truly works!

    http://backyardman.com/uploads/rheem_control.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

MAP sensor;Mass Airflow sensor;Volume Air sensor-All Same? [ 8 Answers ]

97 Nissan Pickup - 160,000 miles - KA24E engine -Check engine Soon Light Code reader says volume air sensor. Is this the same as a mass airflow sensor or the MAP sensor? Where is this sensor located, in the throttle body injection? Just threw a new O2 (Bosch)sensor on it, I lost that bet.. it...

Rheem Hot Water heater lockout [ 3 Answers ]

Hi. I have a Rheem Power Vent hot water heater, model PVW50-36FV, I was painting in the basement with little ventilation. The far right and left LED lights indicate the FV sensor detected the presence of flammable vapors. The unit is shut down and in lockout mode. How do I unlock this unit? Any...

1 hour lockout - What next? [ 3 Answers ]

I have a Rheem Criterion II gas furnace. The unit starts and runs okay most of the time. However it will stop occasionally and will go into 1-hour lockout mode (based on light codes) . What is causing unit to work properly sometimes and not others? I have checked the orange flame light. It...

Gas furnace lockout [ 1 Answers ]

My gas furnace will light, but then the flame goes away within a few seconds. It does this several times and then the LED light blinks six times which the sticker on the furnace indicates means a system lockout. What can I do to repair this?

Carrier Gas heater error code 34 oxide on sensor [ 1 Answers ]

I have error code 34 on a Carrier gas forced air heater. I know on the label error code 34 says to clean a sensor with sand paper. Where is the sensor? Thanks, Speed

View more questions Search