Plus 90 bryant code 23

meadchip Posts: 1, Reputation: 1

New Member

Feb 11, 2010, 11:01 AM

Plus 90 bryant code 23

I disconnected one wire to the pressure switch, reconnected it and the draft inducer started and all was well, for overnight... same problem and solution in the AM.. do I need to replace the pressure switch?

Check out some similar questions!

Bryant code 33 [ 0 Answers ]

Hi, I really hope someone can help me. I have a Bryant 340MAV. I cannot seem to get the furnace to stop flashing code 33. It doesn't go to 13 either, which I find strange. I also tried bypassing the limit switch, temporarily, just to see if this was the problem. Still getting 33. Also...

Bryant Plus 80 code 14 [ 0 Answers ]

I have a bryand plus 80 heater. It will work some of the time but the other times it will try to start and then stop and flash code 14... ignition lockout. What would be causing this.

Bryant code 42 [ 1 Answers ]

When the furnace is given the self test all appear to run fine the inducer hi and low, blower high and low and igniter glows. Furnace shuts down after about 2 min on high output. Could it be the control board?

Bryant code 33 [ 1 Answers ]

Bryant gas funace model 310aav042090aaja. Code 33. Wired around limit and it worked fine. Replaced with new limit throws code again. Vents clear. Filter clear. What next? Is it really getting too hot? Runs about 4 minutes before throwing code and cycles down about 3 minutes.

Bryant plus 90 code 43 [ 0 Answers ]

I have a Bryant Plus 90 series. I'm getting a code 43. From what I gather in my search, does it have anything to do with the blower motor?

View more questions Search

Check out some similar questions!

Add your answer here.