 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant code 33
Hi,
I really hope someone can help me. I have a Bryant 340MAV. I cannot seem to get the furnace to stop flashing code 33. It doesn't go to 13 either, which I find strange. I also tried bypassing the limit switch, temporarily, just to see if this was the problem. Still getting 33. Also tried completely removing the air filter, again temporarily, to see if that would help, no luck. I have tried turning it off for a couple of hours, but 33 starts flashing almost immediately. Thank you! |
||||
Check out some similar questions!
I have a Bryant Plus 80 that is throwing a error of 33 (limit or flame roll out switch is open). The last time this happened was because the hot surface igniter was broken (frequent problem as my furnace has a tendency to short-cycle). I had picked up a couple extra ones so I had them on hand to...
I have a bryand plus 80 heater. It will work some of the time but the other times it will try to start and then stop and flash code 14... ignition lockout. What would be causing this.
When the furnace is given the self test all appear to run fine the inducer hi and low, blower high and low and igniter glows. Furnace shuts down after about 2 min on high output. Could it be the control board?
Bryant gas funace model 310aav042090aaja. Code 33. Wired around limit and it worked fine. Replaced with new limit throws code again. Vents clear. Filter clear. What next? Is it really getting too hot? Runs about 4 minutes before throwing code and cycles down about 3 minutes.
I have a Bryant Plus 90 series. I'm getting a code 43. From what I gather in my search, does it have anything to do with the blower motor?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
